Verse The World Dove Banner

Here’s a step-by-step guide on how to install a decal banner along with instructions on how to properly prepare the glass:

Size:20inx16in

### **How to Prep Glass:**

1. **Clean the Glass Surface:**

   - Use a glass cleaner and a lint-free microfiber cloth to clean the surface where the decal will be applied. Make sure to remove all dirt, dust, and oils.

   - Wipe the glass in one direction to avoid streaks, ensuring that it is completely clear.

2. **Remove Any Adhesive Residue:**

   - If there is any old adhesive left on the glass, use an adhesive remover or rubbing alcohol. Apply the remover to the residue, let it sit for a minute, and then wipe it away with a clean cloth.

3. **Dry the Glass:**

   - Ensure the glass is completely dry before proceeding. Any moisture on the surface can prevent the decal from adhering properly.

4. **Inspect the Surface:**

   - Double-check for any missed spots, dust, or lint. The glass should be perfectly smooth and clean for the best results.

### **How to Install the Decal Banner:**

1. **Measure and Align:**

   - Hold the decal up to the glass and determine its placement. Use masking tape to temporarily hold it in position while checking alignment.

   - Measure and adjust until the decal is centered and straight. Mark the top corners with tape for easy reference during installation.

2. **Peel Back the Backing:**

   - Carefully peel away a small section of the backing from the top of the decal, exposing the adhesive. Be cautious not to touch the adhesive with your fingers to avoid contaminating it.

3. **Apply the Decal:**

   - Begin applying the decal from the top, using a squeegee or a credit card to smooth out the decal as you go. Work from the top down, removing the backing little by little.

   - Apply firm, even pressure to eliminate any air bubbles, moving from the center outwards.

4. **Remove Air Bubbles:**

   - If any air bubbles form, use the squeegee to push them towards the edges of the decal. For stubborn bubbles, gently lift that section of the decal and reapply.

5. **Final Inspection:**

   - Once the decal is fully applied, inspect it for any remaining bubbles or misalignments. Adjust if necessary.

6. **Peel Off the Transfer Tape:**

   - If your decal has transfer tape, carefully peel it off starting from one corner, pulling at a sharp angle. Go slowly to ensure the decal stays in place on the glass.

7. **Allow Time to Set:**

   - Give the decal some time to adhere fully. Avoid washing the car or exposing it to rain for at least 24 hours to ensure proper bonding.

With these steps, your decal banner will look smooth, clean, and professional.